Page 567 - LMS_Catalog_65
P. 567

 ANCHORS & DOCKING
555
 mfr
VET
Vetus Bow Thruster
Motor 12V+ Solenoid
Radio Remote Control
mfr
VET
It has 1 receiver and 1 hand held control with 2 push buttons for one anchor wind- lass or one bow thruster. This remote control is also suitable to operate other electrically driven equipment on board. Additional hand held controls are available separately. CE Frequency: 433 95 Mhz.
Suitable for 12 and 24 volt DC. Maximum range: 164 ft. Guaranteed range 50'. Maximum capacity: 25 amp at 12 volt. Watertight to IP65. Part No. Each
REMCO1 $321.22
   mfr
VET
Complete replacement motor with solenoid set fitted, plus cover with thumbscrews. Fits both Vetus BOW55 and BOW60 12v models.
Part No. Each
SET0060 $1,246.92
  Air vent suitable for hoses with internal di- ameters of 13, 19, 25 and 32 mm. Air bleed connection rotates through 360°. Type: Single Prop. Blades: 6. Thrust: 121 lbs @ 12/24 VDC (4 HP). Operating Power: 12 or 24 Volts DC. Draw: 205 Amps @ 12 Volts DC. Boat Length: 28' - 41'. Tunnel Diame- ter: 5-29/32". Power: 12 Voltage. Ignition Protected: No. Maximum Amperage: 350 (12 V) or 200 (24 V). Range of Boat Sizes*: 29' - 42'. Thrust in Pounds Force: 121 (12 V) or 132 (24 V). Motor Horse Power: 4. Tunnel Diameter (Internal): 5-29/32". Tunnel Mini- mum Installed Length (at Tube Bottom): 12".
Bow Thruster Propeller 4 Blade
  mfr
VET
 Part No.
BOW5512D BOW2512D
Each
$2,887.11 $2,142.00
Original design 4-blade propeller for Vetus 23kgf bow thruster. This includes the mount- ing hardware. Suitable for bow thruster tube of 132mm diameter
Part No. Each
BP90S $160.50
Bow Thruster Propeller 6 blade
mfr
VET
6 blade propellers for bow thrusters. Opti- mised hydrodynamic efficiency. This propel- ler causes only very little cavitation and has a very low noise level. Dimensions: 4-11/32" Part No. Each
SET0086 $81.98 SET0087 $81.98
   Bow Thruster Panel with Joy-Stick
  BPJE2
BP214B
  SET0088 SET0089
$136.63 $136.63
  mfr
VET
Zinc Anode Set
mfr
VET
Replacement zinc collar anode for Vetus Bow Thruster 25kgf. Supplied with two stainless steel Allen head countersunk set screws.
 Control panel with built-in time lapse device when reversing the direction of rotation. Offers optimum safety and performance.
Watertight to IP66.
Part No.
BPJE2 BP214B
Each
Volts
$371.42 12 and 24 V $14.00 Rubber Boot Only
Thruster Control Panel
Part No.
SET0148 SET0150
Each
$51.97 $61.35
Zinc Anode
     mfr
VET
The Vetus BPSE2 bow/stern thruster control panel features directional con- trol buttons, time lapse when chang- ing direction of rotation, and an auto switch-off after 30 minutes of inactivity. Part No. Each Dimensions
mfr
VET
  BPSE2
$260.10 85mm x 85mm
Joystick
Zinc anode for bow thrusters 125, 130, 160 kgf. For the BOW125/130/160 bow thrusters.
Part No. Each
SET0151 $68.31
Lower Unit Compete
mfr
VET
Complete replacement lower unit thruster leg for the Vetus BOW7512 and BOW7524 B models. Tail Piece Complete with spline drive. Tunnel gasket. Tailpiece wedge & gaskets. Securing screws (M8x40 DIN84) with spring washers. Drive pin (5mm x 27.5mm). Anode (Pre-fitted).
   mfr
VET
only for bow thrusters
Joystick only, for panel mounting a bow or stern thruster control. Supplied with quick connectors for BP29 series loom cables. Excluding connection cable. Part No. Each
BPJSTA $180.25
Part No.
SET0035 SET0046 SET0078
Each
$971.21 $1,098.40 $949.89
   BOW THRUSTERS & ACCESSORIES

















   565   566   567   568   569