Page 247 - LMS_Catalog_65
P. 247

 PUMPS
235
 Part No.
36600-0000 36600-0010 30124-0000
Each
$586.27 $603.39 $143.66
Volts
12 DC
24 DC Service Kit
Amps G.P.M.
11 8 5 8
Made of all bronze construction with a rubber impeller for general marine use. 1-HP motor rated at 1750 RPM, 115-Volt or 230-Volt AC. Pumps 20 GPM with a 15 to 20 ft. lift (when impeller is wet). Inlet and discharge are internally threaded for 1" IPS or slip fit 1-1/2" ID hose externally. A vacuum switch is included for automatic cut-off when pump runs dry. Maximum PSI is 43 lbs. Pump weighs 39 lbs. Not Ignition-Protected.
Part No. Each Volts AC GPM
Sea Gulp Bilge Pumps
Heavy-Duty
Bilge Pump
     36600-0000
mfr FIG 3801B JAB
Pumps up to 8.0 G.P.M. Self- priming and runs dry without damage. Belt-driven shaft and connecting rod have perma- nently lubricated ball bearings for long life. Large rubber mounting pads absorb vibration and noise. INCLUDES 36200-0000 In-Line Strainer. 11 lbs. HEAVY-DUTY — Dimensions: 7" Wide, 5-3/4" Long, 8-1/4" High. 3/4" hose connections. Ignition protected.
FIG 4846
mfr
OB405MK-04
OBE OB405MK-04N26
   WARNING: Cancer and Reproductive Harm – www.P65Warnings.ca.gov The Gulper Bilge Pumps
OB405MK-04N26 $1,269.00 OB406MK-04 $819.00
115/230 25 Bilge Pump Head and Switch Only Spare Vacuum Switch
  7046
$175.00
  Intermediate
PUMP INSTALLATION
Sea Gulp Junior Bilge Pump
For Smaller Craft
FIG 3802
   36680-2000
Bilge Pump Switch
FIG 4135
  mfr
JAB
mfr
JAB
Pumps up to 5.5 G.P.M. runs dry without damage, self-priming. Dependable motor draws little current. Belt-driven, with perma- nently lubricated ball bearings on shaft and connecting rod for long life. Large rubber mounting pads cut vibration and noise. INCLUDES 36200-0000 In-Line Strainer. 8 lbs.
INTERMEDIATE — Dimensions: 6-5/8" Wide; 5-3/4" Long, 8-1/4"
Jabsco light-duty bilge pump for intermittent duty in small and medium sized craft. Inexpensive, yet pumps up to 4 G.P.M. Powerful, self-priming, mounts high and dry safely out of bilge, runs dry without damage. Sturdy phenolic plastic body with large rubber mounting pads to absorb vibration and noise. INCLUDES 36200-0000 In-Line Strainer. 7 lbs.
FOR SMALLER CRAFT — Dimensions: 4-3/4" Wide; 7-5/16" Long, 7-1/4" High. 3/4" hose connections. Ignition protected.
Part No. Each Volts Amps G.P.M.
 High. 3/4" hose connections. Ignition protected.
Part No.
36680-2000 36680-2010 43990-0062
Each
$523.78 $541.77 $134.32
Volts Amps
12 DC 7
24 DC 5
†Serv. Kit for 2000 Series
The rubber impeller puppy series are good for bilge pumping, wash down, etc. Has a combination female 1/2" IPS port and 1" OD male slip fitting. INCLUDES two 3/4" garden hose thread adapt- ers. Produces a suction of about 4’ and lifts to 20’ when primed. The 18670 Series have a higher flow rate and feature a long life heavy-duty ball bearing motor. May be reversed to pump in either direction. All are self-priming, continuous duty, and ignition pro- tected and weigh 6 lbs., except 18660-0121 which is 5 lbs.
Part No.
18660-0121/6360-1001†* 18670-0123* 18670-0943* 90061-0003
† Not Reversible
Each
$190.86 $344.14 $344.13
$40.59
Volts
12 DC 12 DC 24 DC
Amps/ @ 10’ head Fuse GPM
8/7 5.4 9/15 7.8 5/10 6.3
*   WARNING: Cancer and Reproductive Harm – www.P65Warnings.ca.gov
FIG 3184
G.P.M.
5.5
 5.5
36960-2000 $418.52 12 DC 6
WARNING: Cancer and Reproductive Harm – www.P65Warnings.ca.gov
4
 WARNING: Cancer and Reproductive Harm – www.P65Warnings.ca.gov Water Puppy
Mini-Puppy Flexible Impeller Pump
JAB
The Jabsco 8860-0001 is
a bronze Flexible Impeller
pump with a Lip Type
seal, coupled to a 12 Volt
DC Motor. This pump has
a nominal flow rate of
1.8 GPM (6.8 LPM), and is
self-priming from dry up
to 4 feet (1.2m) and a lift to
15 feet (5m) when primed.
Be sure suction lines are
airtight or pump will not self-prime. The motor on this pump is a 12 volt DC, Permanent Magnet Type, Fully enclosed, Stainless Steel Shaft, with a 4 amp draw, and requires a 10 amp fuse. The pump must be mounted in a dry location - the motor is not waterproof and must not be submerged.
Part No. Each
8860-0001 $233.84
WARNING: Cancer and Reproductive Harm – www.P65Warnings.ca.gov
    Bilge Pumps
Bronze
mfr
JAB
mfr
      Service Kit for 18670 Series
  BILGE PUMPS

   245   246   247   248   249